For my brehs that use Andis outliners

[Kyle C. Barker]

Do yall be adjusting the closeness of the blade?

I just learned that you could do that about 5 mins ago. And this is after using them shyts for a good 7 years too

And most importantly does adjusting to make it lower give you razor bumps?

 

[calixprynce]

did you modify em yet ?

 

[Primetime21]

I adjusted the blade manually and I've bought an already modified blade from Chuka. In both cases it was a sharper line but I had nicks on the sides of the back of my neck and on the front where are the arches are so I stopped using them. Not to say that's going to be the case for everybody but what I did was bought a pair of babyliss trimmers and put the blade on my andis outliners, cut just as sharp without nicking me

 

[Kyle C. Barker]

did you modify em yet ?

Naw not yet. I'm gonna try some time tomorrow. Would today but I gotta be somewhere in about 2 hours.

I mainly use them to shave my face because all other types of razors make me break out in razor bumps. Even them norelco electric shaver joints

 

[Kyle C. Barker]

I adjusted the blade manually and I've bought an already modified blade from Chuka. In both cases it was a sharper line but I had nicks on the sides of the back of my neck and on the front where are the arches are so I stopped using them. Not to say that's going to be the case for everybody but what I did was bought a pair of babyliss trimmers and put the blade on my andis outliners, cut just as sharp without nicking me

Interesting.


I might experiment with that

 

[intruder]

Subs